Install guide

Document Number 490-0002-01

Revision 04 – 3rd September 2024

What’s in the box?

• Accessia Reader
• Bezel removal tool

What you’ll need

• 2 x 3.5mm diameter (no. 6) panhead screws and wall anchors suitable for the wall surface the Reader will be mounted on
• 5-way terminal block with suitable tool for 24AWG wire connection
• Bezel removal tool (supplied)
• 120 Ohm +/- 1% termination resistor (depending on topology)

Mounting guide

Before you start

• Make sure the wall you want to mount the Reader on is flat and vertical
• Choose a good position that is easy for all users to access, including those with limited mobility
• Make sure there is a hole in the wall behind the Reader which you can pass the integrated cable through
• Avoid mounting the Reader directly onto a metallic surface

How to mount the Reader

1. Remove the bezel. Insert the removal tool into the two holes at the bottom of the Reader. Push the tool in until the clips at the lower end of the bezel release and lift. Unhook the upper end of the bezel and remove it from the Reader (Figure 1)