Door settings

Once you’ve added a door to the site, you can change how the door behaves by clicking the door on the floor plan, and going to the Behavior tab

Unlock methods

Enable or disable hands-free unlock (UWB) and set the range if enabled. Read more about setting up hands-free unlock
Enable or disable PIN as single factor authentication

By default, PINs can only be used for two-factor authentication

Unlock durations

Define how long the door will be unlocked for when users request access from either direction
Define whether the door should relock immediately when it is opened. If this setting is disabled, the door will relock after the unlock duration has been exceeded

If the door does not have a door status input, it will relock after the unlock duration has been exceeded

Define whether an event should be raised in the event log if the door is held open or fails to relock for a set duration

If you only want to raise an event if the door is held open while it is supposed to be locked, select ‘raise held open event only when door is locked’

Reader behavior

Adjust Reader brightness
Enable or disable Reader sounds
Enable or disable Reader flashing while the door is being held open or has been forced open